I've seen the blue frame sprays available on ebay along with the correct Suzuki yellow for the panels. I have also looked at ford engine blue (RAL5010) as it seems to be quite widely available and I'm sure that's been suggested before as a good match. The bike was all back together the other week and I even had a little ride, but when I was giving it a pre MOT going over I noticed there was a lot of free play at the end of the swinging arm when the bike was off the ground. Unfortunately it wasn't the swinging arm bushes, but a combination of play in the three spherical bearings and plain bush on the rear suspension link. After searching on line and pricing up the parts at the local dealer I realised a good secondhand link might be a better option and luckily I managed to get a complete one in good order off a low mileage 1990 bike. With this all cleaned up, fitted and greased there is now almost zero play at the end of the swinging arm. Whilst awaiting the arrival of the suspension linkage I decided to remove the engine again to do the crank seals and bearings as I suspected gear oil may be passing into the crankcase, which was confirmed this afternoon when I removed the barrel. Luckily the replacement seals and bearings that I'd ordered arrived today, so I'll be fitting them tomorrow and hopefully have it all back together by Thursday when I'm back in work. Now I Just need to find a front L/H under tank side panel, preferably in yellow, if anyone has one lying about? Then I'm looking at finally getting the mot done next week, fingers crossed it should be ok.