Hi I’ve recently purchased a 1984 Honda XL125R (Front Drum Brake Model) This is my first restoration project and have recently done the frame, swing arm, suspension, wheels and the front forks so it’s basically a rolling frame and I’ve just started the on the engine (I wasn’t there when I collected the bike but was told it had compression and started but was abit boggy) and was hoping to do a full rebuild on it but I don’t have a clue where to start and and the parts I need for the rebuild e.g. piston kit, gasket kit and how to go about it do I strip the entire engine down to each individual piece, clean, list and reassemble in order and rebuild from there or do I do the top end and then the bottom thanks for any replies