not long had my bike back from the repair shop and as I still have problems with clutch slipping, Im following advice (re:tmbf) and starting to strip down my bike engine (etc.) myself (despite being a complete novice ). hence 2 quick questions; first - i took the clutch apart (which was fitted as new) to see if it had been soaked, as its wet. Only the outer parts of the rings looked wet/oiled and the inside didnt look wet at all. Would this have much bearing at all on the clutch working well? second - after id soaked the clutch for ten mins, i was replacing the springs and one of the screws broke off inside the clutch centre . I wasnt really applying too much pressure either. Is this my fault (and should i be more careful in future) or is it a faulty (cheap!) screw. (luckily i still have my old clutch..). Thanks in advance. Btw, when im finished through doing all this, I may be able to start giving advice instead of asking for it all the time