Raym

Noticed Newcastle Motorcycles had some Furygan Leathers in and i must say the quality looks realy good Quite pricy but i suppose you get what you pay for and there is a interest free offer so i am toying with the idea Anybody any thoughts on Furygan ?

Thanks for the advice guys .. spot on as always Think i will go down the heated grips path

Now that the colder mornings are here i have decided to invest in some eqp to keep my fingers warm . I have been looking at the Oxford heated grips but i have read that even when you switch them off they still can drain your battery ( is that true ) I would have thought once switched off they would be ok . So i have been looking at the Oxford muffs any advice on which you guys prefer would be great Cheers

Thanks for the input guys Its roll up the sleeves time and get sanding

Busy doing up a scooter for my lad for xmas for his comute to collage ,it runs great but the guy i got it off tried painting the front plastics and made a hash of them as in the paint has cracked so i hope to strip it off and try myself do do a better job . Any advice on what to use to strip it would be great Thanks

Managed to pick up a screw in the rear tyre of my Blade on sun. I repaired it using a temp repair kit and having rang around a few motorcycle tyre places cant find one to repair it ( on saying once you have fixed a temp repair you cant repair after that ) I have noticed the mushroom plug kits on the net but not sure if i should go that road but my head is telling me to bite the bullet and get a new tyre Any advive would be great

Decided to take my blade out for a spin as I have only done 70 miles on it since I got it ' so decided on a trip to the borders first stop Carter bar then onto Howick, Selkirk, then on to Moffat . Passed St Marys Loch first time I had been this way so kept stopping to admire the view Roads were ok apart from a few dodgy bits from Selkirk to Moffat ( lots of loose gravel ) All in all a nice run out 228 miles Sorry for the three same photos but new to posting photos Ha Ha

Thanks guys . It seems like buy a Thacham approved one and hope for the best

Hi All I am on the lookout for a good lock and chain , was going to go for a Oxford one but have read a few bad reviews on them Any advice would be great thanks

Hi All I am thinking of getting myself one piece leathers and after searching the web I came across a site called FCMOTO and their prices seem realy good . Has anyone used these ? any advice would be great Thanks

Hi Honda CBR 900 RR

Hi Guys I have noticed a quite small hole appearing in the bottom of my exhaust ( where the down pipes fit into) has anyone got any ideas how to botch it up I was going to try exhaust paste . The bike will only be used for me to travel to work and back so I am not botherd if the repair is ugly . I priced the cost of a new part they aint cheap !! so i hope there is a solution out there Thanks in advance

Thats right mate inlet port .Thanks for the stud exractor , never heard of on until i googled it so its off to buy one

Hi Guys Decided to have a go fitting my scott oiler and over tightend the brass spiggot and it has snapped in the exhaust port leaving half of it in so cant be removed with plyers Any advice on how to remove and what to do would be very very helpful Cheers

Thanks guys, going to have a look today